For example, '14AWG_BLK' and '14AWG-BLK' are among those Layer Names which have been tested. I've tried multiple wire Layer Names from AutoCAD Electrical, including identical names to those found under the Generic wire category from Autodesk Inventor's Cable & Harness Library. My reason for this thread posting is actually to address one such problem:Ĭurrently, when I import a wiring report from AutoCAD Electrical to Autodesk Inventor, I have to manually go through every single wire type in my report (from Autodesk Inventor) to match the wire types with those located in the Autodesk Inventor library. So far, I've successfully managed to import my wiring information from AutoCAD Electrical to Autodesk Inventor, but not without some minor problems. So I've had some measure of success, as I've managed to publish a full electrical schematic using AutoCAD Electrical and I've made it fairly far into my wiring harness project. Actually, I had never used either program before about a month ago. I've taught myself a lot over the past few weeks, though. I'm somewhat new to AutoCAD Electrical and Autodesk Inventor.
